Acts and Regulations

83-42 - General

Section 38
Disposition versions

Full text
38A helmet worn by a motorcycle rider shall conform to the requirements of one or more of the following standards:
(a) United States Department of Transportation, Federal Motor Vehicle Safety Standard 218, Motorcycle helmets;
(b) Snell Memorial Foundation M2010, 2010 Standard for Protective Headgear for Use with Motorcycles and Other Motorized Vehicles;
(c) Snell Memorial Foundation M2005, 2005 Standard for Protective Headgear for Use with Motorcycles and Other Motorized Vehicles; and
(d) United Nations Economic Commission for Europe (UNECE), Regulation No. 22, Uniform Provisions Concerning the Approval of Protective Helmets and of Their Visors for Drivers and Passengers of Motor Cycles and Mopeds.
94-116; 2014-91
38A helmet worn by a motorcycle rider shall
(a) be a helmet of a kind that has been approved by the Equipment Approval Division of the American Association of Motor Vehicle Administrators (AAMVA), or
(b) conform with the standards set out in CAN3-D230-M85[ID#710], “Protective Headgear in Motor Vehicle Applications”, prepared by the Canadian Standards Association, including any amendments, additions or deletions made subsequently to it, or any subsequent editions of it, and shall bear the following label:
94-116